Epoxy resin of liquid consistency. Ideal for Fluid Art technique, pouring finishing layers in paintings and any other products up to 1 cm thick. After hardening, it forms a perfectly even, glossy and transparent coating.

METHOD OF APPLICATION: before use, thoroughly mix component A (resin) and component B (hardener) in the ratio A:B = 100:60 (by weight). The mixing container must be clean. Mixing time – 3 minutes. Mix the resin in one container, then pour into another (without removing the resin residues from the walls and bottom of the first container with a spatula) and mix again. If the resin is not mixed well enough, after hardening, a sticky film may remain on the surface!

Work should be carried out at an air temperature of +20 to +25°C and a relative humidity of about 50%.

After mixing, the resin can be colored in any color with the addition of liquid and solid polymer pigments of different colors. After mixing the components, the working time is about 40 minutes. If necessary, remove bubbles manually or use a gas burner for this. Protect the product from dust while it is hardening. Leave the work for 24 hours so that the resin hardens. Drying time depends on the temperature in the room: at a higher temperature, the resin hardens faster, at a lower temperature – slower.
If you work in the Resin Art technique (paintings/panels/coasters, etc.), sanding and polishing are not required – the coating will be perfectly smooth and glossy. If you work with more complex products and you need to sand and polish them, the resin lends itself well to sanding and polishing. Full polymerization can last for 72 hours from the moment of mixing the components! Until this moment, the material should not be subjected to strong mechanical loads. Unpolymerized resin is difficult to sand.

Do not allow moisture to enter the unpolymerized resin! Do not use wet tools and containers!

Drying time at a temperature of +20 °C and a relative humidity of 50%: from dust – 60 minutes, complete drying – in 1 day.

STORAGE AND SAFETY CONDITIONS: store and transport in a proprietary sealed container at a temperature of +5 to +30 °C, out of the reach of children. Keep away from direct sunlight and heating devices. Use by children is possible only under adult supervision! Containers and product residues are sent for disposal.

Avoid contact of unprotected skin and mucous membranes with resin, hardeners and dust formed during the sanding process. When working with epoxy resin, wear protective clothing, a respirator and rubber gloves. Do not inhale sanding dust, and when machining the finished product, wear a respirator and safety glasses. Do not use solvents to remove epoxy resin from the skin. In case of skin contact with resin, hardeners, sanding dust, immediately remove the resin with dry cloths or a towel, then wash the area of ​​contact with warm soapy water. If a skin rash appears during work, stop working with the resin. If the problem recurs when resuming work with the material, stop working with it and consult a doctor. If resin or hardener gets into your eyes, rinse thoroughly with water immediately and consult a doctor. Avoid swallowing materials. Wash your hands thoroughly after work, especially before eating. If you swallow epoxy resin, drink plenty of water and consult a doctor immediately. When using the product, do not smoke, drink or eat.

Individual intolerance to the material and allergic reactions are possible; if they occur, immediately stop working with the material and consult a doctor.

Kit: component A (resin) and component B (hardener) with a total volume of 1.5 liters.