PURPOSE: for primary or repair painting of plaster, concrete, brick, plastered surfaces, plasterboard and other construction boards inside buildings. Used in rooms that are periodically subjected to wet cleaning. Due to the homogeneous “velvet” appearance, it is especially suitable for ceilings and other demanding surfaces.

SURFACE PREPARATION: clean the surface from dirt and dust. Remove cracked and peeling old coatings. The surface must be dry and clean. If necessary, level with putty, sand the dry surface and carefully remove the dust. Before painting, prime the surface with an acrylic dispersion primer or (for weak, crumbling surfaces) a deep primer, according to the instructions for use. New lime-cement surfaces must be cured for at least one month before painting.

Use: mix the paint thoroughly before use, if necessary dilute with water (up to 10%). Apply with a roller, spray gun or synthetic bristle brush in 2 coats. Drying time at +20°C and 50% relative air humidity – 30 minutes, the next layer can be applied after 1-2 hours, but this time increases as the temperature drops and humidity increases. The rate of surface coverage in 1 layer is 5 – 7 m2/kg, depending on the surface and application method.

STORAGE CONDITIONS AND SAFETY: store and transport in a hermetically sealed container at a temperature of +5 to +35 °C, out of the reach of children, away from heat and direct sunlight. Attention. Use a respirator when spraying. Wet work tools must be cleaned of paint residues and thoroughly rinsed with water. The container and product residues are disposed of as waste after drying.

Country of manufacture: EU