IMPREGNANT FOR STONE, CONCRETE AND PAVING STONES<\/p>\n
A water-based solution based on innovative fluoropolymer technology.<\/p>\n
The formula does not contain organic solvents, so it is safe for both users and the environment, forms a durable
\nand transparent barrier that effectively protects surfaces against water, oil and
\ndirt absorption. In addition, the impregnator provides protection against stains
\nfrom oils, coffee, juices, wine and others. Its vapor permeability allows the substrate
\n“to breathe”, making it suitable for both indoor and outdoor use. The main feature of this product is that it does not change the natural appearance of the substrate,
\ndoes not turn yellow and does not form a film.<\/p>\n
Application\/Purpose<\/p>\n
For the protection of various building materials, including:<\/p>\n
\u2022 Natural stones
\n\u2022 Paving stones
\n\u2022 Terracotta
\n\u2022 Concrete
\n\u2022 Bricks, etc.<\/p>\n
APPLICATION:<\/p>\n
\u203a The surface to be impregnated must be dry, clean and free of grease. It is important to remove all dirt, grease stains, dirt and efflorescence before impregnation.
\n\u203a Stir the product thoroughly immediately before impregnation. Do not dilute. Always carry out a test run.
\n\u203a The substrate must be impregnated with a brush, roller or sprayer, applying one or two coats using the “wet on wet” method.
\n\u203a Do not apply an excessive amount of the preparation to the substrate, remove the excess before drying.
\n\u203a On vertical surfaces, apply from the bottom up.
\n\u203a Drying time is approximately 4 hours and depends on the conditions at the application site (temperature and humidity).<\/p>\n
ADDITIONAL INFORMATION:<\/p>\n
\u203a Optimal conditions of use: temperature from +10\u00b0C to +30\u00b0C and relative humidity below 70%.
\n\u203a Initial surface protection after 24 hours. Full protection after 7 days, until then do not clean the impregnated surface, protect from water and dirt, as well as mechanical damage.
\n\u203a For the care of the impregnated surface, use mild detergents. Do not use rough sponges.
\n\u203a Immediately clean spills from the impregnated surface. Prolonged contact of spilled liquids with the impregnated surface may cause slight discoloration.
\n\u203a It is recommended to re-impregnate the surface after 1 year.
\n\u203a After application, wash tools immediately with water and detergent.<\/p>\n
CONSUMPTION:<\/p>\n
\u203a 10\u201330 m\u00b2\/l, depending on the application method, and in particular on the type and degree of absorption of the substrate. The effectiveness is indicated for one layer.<\/p>\n
NUMBER OF LAYERS:<\/p>\n
\u203a 1 to 2 layers, depending on the type and degree of absorption of the substrate.<\/p>\n
Manufacturer: Inchem Polonia<\/p>\n
<\/p>\n","protected":false},"excerpt":{"rendered":"
Wet stone effect<\/p>\n","protected":false},"featured_media":35024,"comment_status":"open","ping_status":"closed","template":"","meta":[],"product_cat":[1096,450,1155],"product_tag":[6889],"yoast_head":"\n