Certified ETA two-component polyester-based adhesive for threaded rods, dowels, anchors, fittings, etc. for anchoring elements in building materials, such as concrete, bricks, aerated concrete, stone, etc. It is designed for fast fixing of moderately loaded anchor in concrete.<\/p>\n
Characteristics:<\/strong> Fast hardening. For indoor and outdoor use. Also suitable for use at low temperatures, up to -10 \u00b0C. The cartridge should preferably be stored at a temperature of 20 \u00b0C. High adhesive strength, so it can withstand heavy loads. Usable in wet and dry concrete. Free of solvents and styrene. Without smell. Temperature resistant from -40 \u00b0C to 80 \u00b0C. Also suitable for filling holes and cracks.<\/p>\n Purpose:<\/strong> For chemical anchoring of medium load threaded rods, dowels, anchors, fittings, rebars in concrete, bricks, stone, etc. where a European certificate is required. As a repair mortar or adhesive for concrete elements. As an adhesive for facade elements, wooden structures, metal structures, consoles, fences, sanitary equipment, pipes. The glue does not swell during curing. It is used for structural adhesion of reinforcement and installation of screws in newly constructed areas, buildings or in the restoration of precast concrete elements. Suitable for securing doors, fences, blinds, antennas, consoles, cables and also in industrial machinery. At an adhesive temperature of 20\u00b0C, complete hardening takes 24 hours.<\/p>\n Application:<\/strong> Mortar and concrete must be at least 28 days old. The bore should not be greasy and should be thoroughly brushed and blown with air. Unscrew the cap, peel off the foil from the cartridge, cut it off at the thread of the cartridge. Screw on the static mixer, firmly attached to the cartridge. Make sure both ingredients are in a static mixer. Load the cartridge into the gun. The glue is well mixed if it is a uniform gray color. The first 10 cm of mass must not be used for anchoring. Fill the hole from the bottom up. Fill approx. 2\/3 of the hole, but the entire space between the wall and the anchor must be filled to its full depth. Make sure the anchor is dry and clean. The anchor is pressed into the filled hole by slowly turning it, and the glue should flow from the sides of the hole. During curing, the anchor must not be moved or loaded.<\/p>\n Manufacturer<\/strong>: TKK d.o.o. Slovenia<\/p>\n","protected":false},"excerpt":{"rendered":" Certified ETA two-component polyester-based adhesive for threaded rods, dowels, anchors, fittings, etc. for anchoring elements in building materials, such as concrete, bricks, aerated concrete, stone, etc. It is designed for fast fixing of moderately loaded anchor in concrete. Characteristics: Fast hardening. For indoor and outdoor use. Also suitable for use at low temperatures, up to […]<\/p>\n","protected":false},"featured_media":25271,"comment_status":"open","ping_status":"closed","template":"","meta":[],"product_cat":[4456],"product_tag":[],"yoast_head":"\n